SUPPLY COMPANY, INC.

 

5450 W. Jefferson * Detroit, MI  48209

(800) FLOR-DRI * (313) 843-6460 * (313) 843-8948 Fax

 
Locations, Hours & Directions
 
Products
 
Credit Application
 
MSDS
 
Weather Charts
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

       

1. PRODUCT IDENTIFICATION
Emergency Phone Number 312-807-2000
Chemical Name Sodium Chloride Cas# 7647-14-5
Common Name

Super Pellens

Chemical Formula NaCl
Product Names Super Pellens
2. COMPOSITION/INFORMATION ON INGREDIENTS
  Formula Cas# %
Sodium Chloride NaCl 7647-14-5 >99.5
Sodium Citrate C6H5Na3O7 6132-04-3 <0.1
Anionic Surfactant Mixture --- <0.01
3. HEALTH HAZARD DATA
Effects of Overexposure:
Ingestion: Very large doses can cause vomiting, diarrhea, and prostration. Oral toxicity rate LD50: 3000mg/kg
Skin Contact: Mild skin irritant
Eye Contact: Moderate irritant
Inhalation: Inhalation of dust may cause mild irritation to mucous membranes, nose and throat. Symptoms may include coughing, dryness, and sore throat.
Acute Systemic Effects: Dehydration and congestion may occur in internal organs. Hypertonic salt solutions can produce inflammatory reactions in the gastrointestinal tract.
Chronic Systemic Effects: No information found
4. EMERGENCY AND FIRST AID PROCEDURES
Eye Contact: Immediately flush eyes with plenty of water for at least 15 minutes. Call a physician if irritation persists. Hazard Rating (0=None, 4=Extreme)         1 - Health, 0 - Flammability,          0 - Reactivity
Skin Contact: Wash exposed are with soap and water. Get medical advice if irritation develops
Inhalation: Remove to fresh air. Get medical attention for any breathing difficulty.
Ingestion: If large amounts were swallowed, get medical advice.
5. FIRE AND EXPLOSION HAZARD DATA

Product is non-combustible; no extinguishing media or special fire fighting procedures are required. There are no unusual fire or explosion hazards.

6. REACTIVITY DATA
Stability Stable; Stable and inert under normal conditions. No hazardous polymerization can occur. No hazardous decomposition products or conditions.
Materials to Avoid Will react with strong acids (to generate hydrogen chloride) and strong oxidizing agents (to generate chlorine gas)
7. PHYSICAL DATA
Appearance White Pellets pH 7.5-9
Odor None % Non-Volatile 100
Density (Water=1) 2.165 g/cc Vapor Pressure   (mm Hg) 1 mm @ 865oC (1589oF)
Solubility in Water 36 g/100 cc water @ 20oC (68oF) Boiling Point     (760 mm Hg) 1413oC (2575oF)
8. SPILL OR LEAK PROCEDURES
Response to Small Spills Sweep up and containerize for reclamation or disposal. Vacuuming or wet sweeping may be used to avoid dust dispersal
Response to Large Spills Shovel and sweep up; Containerize for reclamation or disposal
Hazards to be Avoided None
Reportable Quantity Check your state for requirements
Waste Classification Some states have set maximum limits on chlorides in waste effluent
Disposal Methods Whatever cannot be saved for reclamation may be delivered to an approved waste disposal facility or if local ordinances allow, can be dissolved in sufficient amounts of water to meet water quality standards, and flushed down a sewer drain. Ensure compliance with local, state, and federal regulations.
9. SPECIAL PROTECTION INFORMATION
Respiratory Protection For conditions of use where exposure to the dust is apparent, a NIOSH approved dust/mist respirator may be worn. For emergencies, a self-contained breathing apparatus may be necessary.
For Hands, Body If deemed necessary, wear protective gloves and clean body-covering clothing.
For Eyes: If deemed necessary, use chemical safety glasses or goggles. Contact lenses should not be worn when working with this material. Eye wash fountain or water for eye washing should be available.
Ventilation In general, dilution ventilation is a satisfactory health hazard control for this substance. However, if conditions of use create discomfort to the worker, a local exhaust system should be considered.
10. SPECIAL PRECAUTIONS

Transport in dry equipment; store in dry location. Handling procedures should minimize generation of airborne dust. Dust respirator as appropriate where exposure exceeds the 10 mg/m2 ACGIH TLV for nulsance dust.

11. LABELING INFORMATION
DOT Shipping Name Salt (common) Sodium Chloride UN No. N/A
DOT Label N/A Additional Product Label N/A
Warning None

The responsibility to provide a safe workplace remains with the user. The user should consider the health hazards and safety information contained herein as a guide and should take those precautions required in an individual operation to instruct employees and develop work practice procedures for a safe work environment.

The information contained herein is, to the best of our knowledge and belief, accurate. However, since conditions of handling and use are beyond our control, we make no guarantee of results, and assume no liability for damages incurred by use of this material. It is the responsibility of the user to comply with all applicable federal, state, and local laws and regulations. Nothing contained herein is to be construed as a recommendation for use in violation of any patents or of applicable laws or regulations.

For Questions or Comments about this website, contact master@flordrisupply.com